The Options on the Debugger Screen
The options available on the debugger screen are listed below. Each option is described in detail in a following section of this manual.
Go [Option 0]- Resume normal execution.
Cancel [Ctrl+F8]- Abort process being debugged.
Single Step [RETURN] - Execute the current line and stop on the next line in the current routine.
Step Into [Option 1] - Execute a process or subroutine and stop on the first statement of the routine.
Step Return [Option 2] - Resume execution and stop on the next RETURN statement.
Step End [Option 3] - Resume execution of the current routine and stop on the last statement in the routine.
Toggle Trap [F3] - Enable/Disable a trap on the current statement.
Edit Values [F12] - Edit the value of the variables on the current statement.
Inspect/Edit Value [F11] - Inspect and/or edit the value of a specified variable
View Process Stack [Ctrl+1]
Watchpoint [F10] - Set or Clear watch points on individual variables
Execute Next [F9] - Set next statement to execute
Add Mode
Inquire Mode
Change Mode
|